Fanuc 6tb Maintenance Manual
. FANUC 6TB does not start up Motor Alarm LED On.
Fanuc Maintenance Manual Pdf
IMPORTANT: To post you must be registered AND you must confirm an email sent to you after registering. If you do not received the email, check your junk email, also try to register again (maybe you miss entered your email address which is why you did not receive the email. To register click here before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. Open up the electric cabinet and look for the spindle drive, it probably has a FUJI DC spindle drive, if this is the case, look for a red led being ON (with the machine ON also). Again, if this is the case, see what the small letters next to the red led say, they refer to the kind of trouble the drive has.
- Items 1 - 10 of 73 - Machinery Manuals Parts Lists Maintenance Manual Service. Ikegai AX20 and AX25II, Fanuc 6TB, Lathe Operations Maintenance and.
- Fanuc 6T Maintenance Manual. Views: 95722. Continue with reading or go to download page. Read Download. Fanuc 16i-LB Maintenance Manual. Fanuc 0i-MODEL D Maintenance Manual 64305EN. Fanuc AC Spindle Servo Unit Maintenance Manual.
Post here your findings, once we know what led is ON, perhaps we could give some more advice. If it's not a FUJI drive, than it is a Fanuc one, but same case again, look for leds that are ON and tell us. I assume you have used this machine before with no alarms showing.
FANUC Series 21i-MODEL B. FANUC Series 210i-MODEL B PARAMETER MANUAL B-6361 OEN/01 • No part of this manual may be reproduced in any form.
When you turn on the unit and come to the display that your picture shows, you will then press the 'Hyd./Lub' button, making machine ready to start. (picture shows 'not ready') Then the motor light comes on? If the light comes on before starting program or manual spindle rotation, check brushes and wiring to motor, and as stated above, look for alarm code and LED on boards, also check fuses in cabinets. I have a 4NE-600 with 6T control, if any information from my manuals would help, post email or skype info. Hi John i have a similar issue with tha same model of machine.